Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Flywheel Specs 200

I finally found the specification for the step height on our flywheels.

.947"

For those that do not know the problem arises when you send your flywheel to a machine shop and they take the same amount from the center (friction surface) and the outside (pressure plate bolt surface). That is a problem because the friction surface wears as you use the clutch. So you end up with a disproportionate amount and a looser clutch.

Therefore next time you get your flywheel machined insist upon a 0.947" step!

And if we can save that so it is easily searchable for the world that would be amazing!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Flywheel Specs [200]
posted by  AndrewSpencer  on Sun Oct 4 17:20 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.