Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2018 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

MAP tubing on a Regina 740 700

posted by  Will740turbo on  Thu May 30 03:17 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 16:09 CST 2014
[RELATED]

Hi all. 1990 740 NA rex/regina:

I'm new to Regina, and to MAP sensors. I'm trying to get this car into better working order, and there is a rough transition from idle to off-idle. It's like a delay when you open the throttle, even though the TPS is adjusted and working. The engine hesitates substantially, and then revs after a split second of the throttle being open, unless it's opened very slowly. I haven't dug into it too deeply, but the tubing for the MAP sensor (mounted on the driver strut tower) was clear vinyl and seemed definitely wrong to me. I have a suspicion that the tubing is very important for this sensor.

What type of tubing is OEM? I've seen mention of 90-degree elbows. I'm imagining some 90-degree rubber elbows and that semi-rigid small-orifice plastic tubing - sort of like what's used on the heater vent.

Does anyone have a photo of theirs if it's the original line?

Thanks!
Can't wait to get back behind the wheel of a brick :)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED MAP tubing on a Regina 740 [700]
posted by  Will740turbo subscriber  on Thu May 30 03:17 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.