Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1992 Volvo 240 Exhaust Gasket Manifold Studs Removal Breakage 200

posted by  someone claiming to be Build on  Wed Mar 27 13:34 CST 2019 [RELATED]

Hi Everyone,

I've decided to replace my, slightly leaking on one cylinder, exhaust gasket. This has been ongoing for awhile and I've tolerated it because I don't want to break the studs on removal, and make a tiny annoyance into an all day project.

I've been spraying the nuts daily for a couple months with PB Blaster, but upon heating them with a torch and trying to loosen, they are still tight, zero movement, feel like they will break. I have replacement studs and nuts for all of them, and easy outs, drills, taps, if things go wrong.

Any ideas of how to proceed without things going wrong?

Thanks, Jim






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 1992 Volvo 240 Exhaust Gasket Manifold Studs Removal Breakage [200]
posted by  someone claiming to be Build  on Wed Mar 27 13:34 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.