Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1994 940 Turbo -- Replacing PCV Oil Trap (hopefully without pulling intake man) 900 1994

posted by  rob2volvos on  Thu Oct 25 17:43 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 12 07:52 CST 2014
[RELATED]

I am attempting to replace the PCV oil breather separator box on a 1994 940 turbo.
Question -- Is it possible to do this without removing the intake manifold? If so, how is this done? The FAQs suggest that it is, in fact possible -- but I can't see it.

Having removed nothing I am tantalizingly close to doing so, but I am now in a bind -- I have obtained access to the PCV box, removed the 2x 12mm bolts holding it down, and 2x 10mm bolts securing the base-plate with the wiring harness in front of it. The PCV breather box now lifts up off the block just less than 1 inch but I can't rotate it or tip it far enough to get it out of its housings. Afraid of shattering something. Is there a trick to this?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1994 940 Turbo -- Replacing PCV Oil Trap (hopefully without pulling intake man) [900][1994]
posted by  rob2volvos  on Thu Oct 25 17:43 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.