Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1990 - no start but cranks - should FI relay click with ignition? 200

I've found in the archive all the posts about the sequence of the FI. My simple question is when should we hear the FI relay click. I always thought it happened when the key was on with the warning lights regardless of what other electrical problems may exist like the cps or power stage.


I recently replaced the main pump due to a no start. Jumped fuses to diagnose. It ran fine then the next time I attempted to start it nothing. I jumped the neutral safety switch since I've had issues with it recently. I looked over and cleaned all fuses including the 25 amp FI fuse since the dash lights are out too. Fuse 16 is fine. I did recently have water on the fuse panel from either a leaking windshield or rusted vent. Although car has zero rust. Swapped out the power stage. No gas smell. CPS looks good with no frayed wire or misshaped. Will swap with another to make sure. Swapped out the ECU even though it wasn't a pink label. OBD light comes on when pressing button but then nothing after that. No codes at all.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1990 - no start but cranks - should FI relay click with ignition? [200]
posted by  transit wind subscriber  on Fri Aug 17 15:21 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.