Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

pull transmission 900

Can someone share an experience of pulling a transmission off a 900 series car from underneath under "home garage" conditions? I measured 23" for the height of a AW30-40 transmission put on my transmission jack (which is 8" in height by itself). Seems a little tricky to raise my car by that much: my floor jack has 20" height fully extended, and the jack stands are only 17" at the highest position. Harbor Freight sells 6-ton stands which are 23 5/8" tall (about $180 for a set of 4...) This seems like the way to go (I could use wood to extend the reach of my jack by a bit I guess). Or perhaps I could get the tranny off the jack and onto a piece of plywood/cardboard and pull it out (that saves about 8" in height). The thing didn't seem that terribly heavy when I was handling it. Any ideas would be appreciated.
--
'98 V90 234K '98 V90 157K '94 940 NA 189K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New pull transmission [900]
posted by  vp965  on Wed May 30 11:05 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.