Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2024 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

New Blower motor installed 700 1991

posted by  chuffsy on  Sat Jan 23 10:24 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 18:17 CST 2014
[RELATED]

After many years of living with a 'chirpy" blower fan , I finally installed a new one obtained from FCPEuro. Mine is a two terminal one and not the single type even though the new unit (vdo #PM3787)came with instructions for a retrofit. The fan on the new one is an inch shorter and the blades are spaced out a tad wider. As I suspected the airflow is not as forceful as the original , nonetheless adequate for my needs. To install remove the lower kickboard that covers the ECU. Remove the ECU and its bracket. There are three 7mm screws holding the fan assembly in place. I suggest you remove the screw next to the firewall first then the others. Before you reinstall check that the fan works .
Regards
Paul






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 New Blower motor installed [700][1991]
posted by  chuffsy subscriber  on Sat Jan 23 10:24 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.