Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Driveline Vibration after New Driveshaft Support Bearing 200 1992

posted by  WhiteT5 on  Tue Nov 17 19:37 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Apr 12 19:20 CST 2012
[RELATED]

The car in question is a '92 240 with approximately 240k miles.

I replaced the driveshaft support bearing on said car last night with a new FAG brand bearing, Meyle support bushing, and new spring. I marked the junction of the DS to rear diff and the halves of the driveshaft with whiteout before I took anything apart. I took this measure even though our car has the factory arrows on the driveshaft to help with alignment.

Everything seemed to go smoothly. The old bearing came off without too much trouble, the new one went on pretty smoothly, and everything lined back up pretty nicely. Car repairs never go so smoothly, so I knew something was amiss.

Sure enough, I went for a test drive and found that the car now has an obnoxious driveline vibration at all speeds. What should I be looking for here?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveline Vibration after New Driveshaft Support Bearing [200][1992]
posted by  WhiteT5  on Tue Nov 17 19:37 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.