Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 fron bumper cover side guides 200

posted by  someone claiming to be Broos on  Fri Aug 28 20:44 CST 2015 [RELATED]

I am in the process of replacing my front bumper cover. I have everything assembled on the aluminum reinforcement and have run into trouble at the point where the guides inside the ends of the plastic cover have to slide over the flat top of the tee-shaped plastic posts that are mounted on the sides of the fenders.
Getting the cover off over those posts was easy enough...

I thought of just undoing the plastic posts from inside the fender but the 10mm head bolt in there seems to spin something in the "stem" of the plastic post. I'm afraid I am going to break something I will be sorry about.

Does anyone have a good method of engaging the slide guides inside the bumper cover with the posts on the fender as you mount up the front bumper that they could share?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 fron bumper cover side guides [200]
posted by  someone claiming to be Broos  on Fri Aug 28 20:44 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.