Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Body panel installation question... 200 1989

uid 33936's pic
posted by  TheBrickTank on  Sat Aug 15 15:06 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 17:54 CST 2014
[RELATED]

So back in June, my son crashed my 1989, 245 into the rear of Ford F-150.

Yesterday I got the hood, front cross member and drivers side front fender back from the paint shop.

So far I've place the drivers side fender, though I have not tighten the bolts completely tight. Today I placed the front cross member in place but I have not tightened any of the bolts as I'm not sure about any alignment issues that might arise once tightened.

Can any one help me here and tell me how I should proceed with this the remaining installation of the front cross member and then the hood.

Thanks in advance,

Matt





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Body panel installation question... [200][1989]
posted by  TheBrickTank  on Sat Aug 15 15:06 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.