Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Brake bleeding Very frustrated 200

posted by  Grassman on  Fri Mar 13 06:57 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 4 07:10 CST 2014
[RELATED]

I have an 1988 Volvo 240 project car that I did alot of work to. Summary, New front hoses(4),front calipers,rotors,pads and master brake cylinder(ATE). I bled the brakes a few times following the procedure in the bentley manual. There are no bubbles at the bleeder screws and yet the pedal goes to the floor. I'm using a Motive brake bleeder at 25psi. This is not my first brake job but am at the end of my rope. My first 240 brake job. Any ideas?? Thanks Matt






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake bleeding Very frustrated [200]
posted by  Grassman subscriber  on Fri Mar 13 06:57 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.