Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2010 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Koyo Rack outer Tie rod end 900 1993

posted by  Onkel Udo II on  Fri Sep 19 11:59 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:50 CST 2014
[RELATED]

So the alignment shop that I actually trust sent me away with a 940 wagon unable to be aligned. I suspected as much ahead of time but the reason shocked me...the tie rod ends are completely fused to the tie rods. For grins I pulled the whole tie rod with end attached, put it in the vice and wailed on it with a pipe wrench and it is not going anywhere.

After investigating the options for my Koyo rack it because clear that a rebuild rack from Jorgen was basically only $25 more that two new inner rods so I made the obvious choice. Here is the rub...

I want the MOOG or OEM quality outer rod ends but I am having a hard time verifying the part. Everyone lists the CAM/TRW and the ZF but I only find off-brands listed for the Koyo. Searching the archives leads me to believe that the outer is the same as the Cam/TRW but I would like verification before ordering. Can anyone absolutely swear they are the same?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Koyo Rack outer Tie rod end [900][1993]
posted by  Onkel Udo II subscriber  on Fri Sep 19 11:59 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.