Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 Resurrection - Rear brakes no fluid from bleeders 200 1990

posted by  BrickDad on  Mon Aug 18 10:56 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:17 CST 2014
[RELATED]

As the resurrection progresses, I was bleeding/changing brake fluid using a power bleeder setup at 15 psi. When attempting to bleed the rear brake calipers I got no flow from either side. Removed and cleaned out both bleeders and no flow even with the bleeders out. All front bleeders operated as advertised and bled until clean fluid was seen.

The archives seem to have several instances of this happening but I don't seem to see what the solutions have been. Comments appreciated from the list experts on my plan below:

1. Break connections from each caliper forward until I get flow then attempt to remove and blow out downstream lines.

2. Plan on replacing both rear calipers with rebuilt units as they are probably locked up with no fluid for some time.

Brian Mee





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 Resurrection - Rear brakes no fluid from bleeders [200][1990]
posted by  BrickDad  on Mon Aug 18 10:56 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.