Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

TZ-28H problems 200 1990

posted by  someone claiming to be taajaasne on  Wed Jul 2 05:24 CST 2014 [RELATED]

Hi Sages.

I think I have a problem with my carbed B230K '90 240.
It does not have any EZK computer, just plain Hall sensor + ignition module (TZ-28H).

The problem:
The engine is aligned OK (checked it multiple times).
When I align the distributor according to manuals (the notch in the middle of the rotor, the #1 cylinder point directly over it) the ignition is so out of time, it does not run. When I rotate it counter-clockwise, maxing out the adjustment, it kinda runs. To time it properly (12 degrees BTDC, using timing light), the distributor has to be put in "incorectly", with the rotor pointing somewhat between points.

Engine runs ok, has power, but shakes quite severly on idle (no stalling though).
The rotor (rev-limiting type), cap and leads are new, the plugs have about 2000 miles on them.

Is it the hall sensor, the ignition module, or something else is messing my timing? How to diagnose?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New TZ-28H problems [200][1990]
posted by  someone claiming to be taajaasne  on Wed Jul 2 05:24 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.