Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Blower impellers stuck on shafts, 1992 240 wagon 200

posted by  pastorbud on  Sun Feb 16 21:25 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Feb 22 22:11 CST 2014
[RELATED]

Doing the dreaded blower motor replacement. That guy at cleanflametrap.com really put a good tutorial together!

So, I got the dash, etc. all tore out and was pretty excited by how well things were going, until.....

I got the clips off, and the impellers will pull off the shaft until about 1/8 of shaft is exposed, and then they seize.


The blower motor was way worn out. Only ran on high, and started smoking! It probably has about 1/2 inch of play left-to-right and up and down.

Either the shaft overheated and mis-shaped the impeller core, or (more likely) it's just got corrosion and gunk on that exposed tip. I've tried to clean it up with a screwdriver tip... no luck


My current plan is the put blocks between the back of the impeller and the housing and try to drive the shaft out with a punch.

Anybody know a better way?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Blower impellers stuck on shafts, 1992 240 wagon [200]
posted by  pastorbud  on Sun Feb 16 21:25 CST 2014 >
  • New Sand [200][1992]
    posted by  Art Benstein subscriber  on Mon Feb 17 10:14 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.