Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Put slightly damaged breather box back or use new oem one 200 1989

posted by  stallison on  Sat Feb 1 18:49 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 20:06 CST 2014
[RELATED]

Got the breather box out, luckily. It took some serious effort and removal of quite a few extra parts. Biggest thorn in the side was the egr california stuff mounted to a bracket that is attached by breather box bolts. Couldn't get at the bolts without removing the egr thing.

So, upon trying to pull the BB up and out, had to tilt it back towards driver's side and then up. Otherwise it would get stopped by heater core hose above it.

Once I got it out I was soaking its innards and knocking the crud loose with a mallet when I noticed the smaller bottom stem was slightly broken. NOt completely broken off, but enough to make me suspect. Its broken about halfway around where the stem connects to the main body of breather box.

If the breather box sits back in pretty snug and is tightened down this might not be a problem.

I'm leaning towards using the new one






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Put slightly damaged breather box back or use new oem one [200][1989]
posted by  stallison subscriber  on Sat Feb 1 18:49 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.