Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

front wheel stud replacement/anti-lock brake ring 1992 240 200

posted by  pastorbud on  Fri Jan 17 18:04 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Feb 22 22:11 CST 2014
[RELATED]

I am replacing two front wheel studs on a 1992 240 wagon. I've done this before on other cars, and never run into this:

I removed the brake caliper, and the rotor. I heated up one broken stud and it hammered out so easily, that I just took a coupla good bangs on the other and out it came.

But... the broken studs were short enough to clear the anti-lock brake ring (the toothed thingie that activates the sensor when the wheel turns) on the back of the hub.

The new studs, of course, are longer, and those studs won't clear the anti-lock brake ring when I try to insert them.

So... Can I put a puller on that ring? The outer toothed rim looks too flimsy for that. How does it come off?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New front wheel stud replacement/anti-lock brake ring 1992 240 [200]
posted by  pastorbud  on Fri Jan 17 18:04 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.