Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Hmm.. can't get front hub off, ?? 200

posted by  keithostertag on  Fri Oct 25 09:04 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 17 15:10 CST 2014
[RELATED]

My first try at replacing front wheel bearings. I have read the tutorial here on the BB (thanks Goatman!) and elsewhere.

I'm surprised I can't seem to get the hub off, after removing the wheel, caliper, rotor, cap, and castle nut. There was a thin spacer behind the castle nut.

If I read the directions correctly, the hub should pull off. I have lightly hit it with a hammer to no avail. There's about an 1/8 travel in it.

Am I missing something that needs to be removed? or is it just stuck? I shouldn't need a puller of some type, correct? Suggestions?







Thanks,
Keith Ostertag






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hmm.. can't get front hub off, ?? [200]
posted by  keithostertag subscriber  on Fri Oct 25 09:04 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.