Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Reverse Lights switch wiring question 200 1989

posted by  stallison on  Fri Oct 4 07:48 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 20:06 CST 2014
[RELATED]

Hello All,

My reverse lights have been out for a while now. I figured it out a while ago that something or the repair shop shredded the wiring that runs from underneath the transmission into the stick shift area. There are still wires in the stick shift area and they are just kinda ripped/cut. Two or three times I have bought different size female wire connectors to attach to the switch sensor on the top of the transmission. I have not been able to find a female connector that will fit snugly on the male prong of the switch sensor.

Do I have to buy a new swithc sensor with wires already on it? Also, if I can acquire the correct female wire connectors can I avoid lowering the transmission to attach them to the sensor? It is kind of a pain to get my hand up in there to access the top of the sensor, but I'd rather not have to lower the transmission if possible.

Thanks
Marc






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Reverse Lights switch wiring question [200][1989]
posted by  stallison subscriber  on Fri Oct 4 07:48 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.