Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2024 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Control Arm Bushing Replacement 200

posted by  dobber13 on  Thu Aug 29 19:45 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 19:10 CST 2014
[RELATED]

I replaced the control arm bushings and found:

1.The front passenger side rear control bushing pressed out with ease. The new one slid on easy.

2.The rear bushing bracket slid on to easy and I noticed that the 3 bolt holes seemed to be slotted?

I emailed FCP before buying the front rear control arm bushing since they didn't show a left or right side bushing.They told me they where both the same. But Volvo shows they are different. Anyone have a problem with them sliding on when they should be pressed on?
If not then I guess the bracket could be bad. What do you think?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Control Arm Bushing Replacement [200]
posted by  dobber13 subscriber  on Thu Aug 29 19:45 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.