Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Seperating exhaust pipes?? 700 1992

posted by  raidman on  Fri Aug 16 20:56 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 22:17 CST 2014
[RELATED]

I scored a very low mileage exhaust system (cat back)= 2 mufflers plus connecting pipes. In order to install in my garage ( no lift) I need to separate the front muffler at the pipe that goes over the rear axle. I have removed the clamp. I have soaked the joint with PBlaster good, I have opened up the metal somewhat with a screwdriver and hammer. But it still remains stubbornly stuck together. I know if I had a torch, it would be short work. Is there a trick or some hammer technique or is it a 2-4 person job to twist off the pipes?
Any help would be appreciated.
el Raidman






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Seperating exhaust pipes?? [700][1992]
posted by  raidman  on Fri Aug 16 20:56 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.