Volvo RWD 444-544 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2005 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

propeller shaft adjustment? 444-544 1958

posted by  Boobtube on  Fri Apr 19 09:26 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 06:19 CST 2014
[RELATED]

1958 444
Here's my situation now. I replaced the carrier bearing in the front drive shaft and also the transmission mount. All fits nicely but when putting in the rear drive shaft, there is now a space between the flange and pinion flange. Can the rear drive shaft be adjusted at all, length-wise.
The carrier bearing housing was not snugged up correctly in the past and so it would seem that making this right has now shorted the overall length. Is the only solution to loosen up and pull out(slightly) that flange on the carrier housing again?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New propeller shaft adjustment? [444-544][1958]
posted by  Boobtube subscriber  on Fri Apr 19 09:26 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.