Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tracking down ECT issue with ohm and v readings 200 1992

posted by  Philip on  Tue Jan 29 12:21 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 10:21 CST 2014
[RELATED]

The care dies from idle if you give it gas until it warms up. The codes say it is the ECT. I replaced the ECT sensor with a URO. No change.

I then back measured from terminal 13 to 5 and got 6.05 volts with the ignition switch on. With the connector unplugged from the ECU, I got 8,200 ohms between 13 and 5.

So does this point to digging into the wiring harness below the 2 and 3 intake manifold and looking for the cold joint on the ground (described by a post on the Brickboard), or looking elsewhere?

Any help would be greatly appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tracking down ECT issue with ohm and v readings [200][1992]
posted by  Philip  on Tue Jan 29 12:21 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.