Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing Intake Manifold gasket: How to remove fuel rail? 200 1993

posted by  Cabbie on  Sat Jan 26 11:09 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 2 15:54 CST 2014
[RELATED]

'93 245

Trying NOT to damage the fuel rail and hoses, but having a hard time disconnecting the top hose (not sure which is supply and return hose; hence the word "top")that has what looks like a screw on fitting. Using two wrenches, it won't break away even after WD-40. Scared of twisting the whole darn thing off... The other (smaller) hose doesn't look as wicked since it has clamps. This "top" hose appears to be a hose-within-a-hose, that is, smaller plastic tube inside the hose. I tried pulling on the plastic tube, but was scared that it might not come out, so then went to trying to use two wrenches to loosen the fitting. Any ideas?

Thanks,
Cabbie





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing Intake Manifold gasket: How to remove fuel rail? [200][1993]
posted by  Cabbie  on Sat Jan 26 11:09 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.