Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2015 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Using plastigage 120-130

posted by  DBS on  Thu Nov 22 21:26 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 19:33 CST 2014
[RELATED]

Hope everyone had a nice Thanksgiving. We did.

I also had the opportunity to use plastigage to measure the clearance between the rods and journals.

Results: the squashed plastic line was barely as wide as the .003 measurement indicator on the gage.

Which means the clearance is over .003.

And to be sure...when I got the plastigage kit, it came with two colors, red and green. Is there a difference which I should use (I had used green)?


Anyway, with the clearance being above .003, which rod bearing size should I get? Standard?

By the way, I also meausured the journals all around...all looks good.

Thanks,

-DS






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Using plastigage [120-130]
posted by  DBS  on Thu Nov 22 21:26 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.