Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front Strut install maybe DONE 200

posted by  jwheli on  Sat Sep 29 18:54 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 12 11:19 CST 2014
[RELATED]

Okay, I did the strut installation and I have a question...

Everything went just as planed however, I think (i think) that the top 15/16 strut nut is not tight enough to the bearing mount. I can not seem to tighten the nut any further and it appears that there is a slight space between the bottom of the nut and the top of the bearing. I only have an impact socket and not a the offset wrench. So my question is, can I hold the strut below with a vise grip and then try to re tighten the nut?


I hope that there are still some threads left on the strut to do so. The new nut that came with the Sacs struts were NOT the short nuts but tall ones. So I do not think a washer was needed.

The car runs like silk on the freeway but getting on the side roads and hitting those cracks or variations between sections, sounds like the front end is going to fall apart. Sounds like metal hitting metal.
Judd






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front Strut install maybe DONE [200]
posted by  jwheli  on Sat Sep 29 18:54 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.