Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M46 shifter bushing install woes 200 1986

posted by  Xraybob on  Sat Sep 15 07:11 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

Just installed my 'new' M46 tranny replacing my AW71. My current problem is that I placed new shifter bushings in the shifter fork and now I can't pass the retaining pin fully in place. I can only get it across to its full seated position about 80% of the way because it's so tight. For now, I'm going to place the locking screw and hope the pin doesn't back out. As tight as it is now, I don't think it will. Any suggestions or comments will help greatly.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M46 shifter bushing install woes [200][1986]
posted by  Xraybob  on Sat Sep 15 07:11 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.