Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replacing Control Arms 200

posted by  jwheli on  Wed Jun 27 22:19 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 12 11:19 CST 2014
[RELATED]

I will be replacing both control arms and would like to know about the two outer bolts that hold the ball joint to the control arms.

Mine are flat on top and pressed in like a wheel studs. Should I be removing those to use in the new control arms? Or will the standard bolts that come with a new set of ball joints fit and not interfere with the strut housing?

If I do remove them, what is the suggestion as to how. I was thinking of a using a nut screwed part way and then tapping it out with a hammer.

Thanks
JW






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing Control Arms [200]
posted by  jwheli  on Wed Jun 27 22:19 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.