Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2023 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1989 240 25" Breaker Bar Bending When Tightening Balancer Bolt 200

posted by  cgilmore on  Tue Jun 19 20:16 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 16:22 CST 2014
[RELATED]

Hi Everyone:

I am using the Volvo counter hold tool to tighten the balancer bolt.
I have tightened the 44 lbs. or 60nm and now have tried to get the additional 60 degrees called for by Volvo.
I can't get it done - my 25" 1/2" drive breaker bar is bending after about 45 degrees of turning on the balancer bolt.
Any thoughts?
Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1989 240 25&quot; Breaker Bar Bending When Tightening Balancer Bolt [200]
posted by  cgilmore  on Tue Jun 19 20:16 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.