Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

89 240 Replace or Keep Worn Crank Timing Belt Guide 200

Hello Everyone:

I recently had my 1989 240 balancer get loose.
I then found that the crank timing gear index pin/key that
indexes to the balancer had sheared of.
So, I bought a new crank timing gear and while starting the
install I noticed that part of the old timing gear index pin / key
was still stuck in the front belt guide / guard.
I tried to get it all out but ended up with what I see as a
curved index pin/key slot - please photo.
It looks like it could cause the timing to be off a least a few
degrees because it appears curved -- or perhaps I am wrong.
That is to say when I go in to align everything , the Timing Index Mark - the little V slot at the top of the belt guard might be off because of
the curve I see in the index key/ pin slot.
Question - does this appear to be significant and should this item be replaced?

Thanks for your input..

Photobucket







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 89 240 Replace or Keep Worn Crank Timing Belt Guide [200]
posted by  cgilmore  on Sun Jun 10 17:35 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.