Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2010 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

hardened valve seats on a B20E 1800 1970

posted by  blitzwagon on  Fri Jun 8 10:03 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 24 10:30 CST 2012
[RELATED]

Hi All,

I'm building a performance B20E and it's been ported with standard sized stainless steel inlet valves but stainless exhaust valves enlarged to 36mm. The machine shop also installed hardened seats on both inlet and outlet.
The engine is part of a long restoration and hasn't run yet.
I've just read that hardened valve seats on the inlet can compromise the water jacket - is this true? THe machine shop don't have that much B20 experience but didn't mention anything about having gone through the water jacket when they were done and it's too long ago for them to remember the job for me to go back and ask.
Is this something I should lose sleep over?

Thanks
Josh






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New hardened valve seats on a B20E [1800][1970]
posted by  blitzwagon  on Fri Jun 8 10:03 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.