Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

header pipe parts? 200 1993

posted by  robbmcc on  Thu Feb 23 09:28 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 08:41 CST 2014
[RELATED]

Hi All,
Trying to order a new header pipe (yes cracks around the y weld) and it's confusing what gaskets and fasteners to get. I have non-EGR with floating flange at the cat end. At the cat end eeruoparts has the 3 bolts nuts and washers and they specify the triangular gasket. But over at FCP they have the round donut gasket listed. Do I need that at the cat end as well as the flat gasket? Also nobody I have seen yet lists what fasteners I need at the manifold end. Is it just the same nuts as the cat end?
Thanks,
Robb






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New header pipe parts? [200][1993]
posted by  robbmcc  on Thu Feb 23 09:28 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.