Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Source of leak 200

If you suspect a leak through the firewall, check where the hood pull cable exits.

With an '89, I found that the drain hole at the base of the metal in the engine compartment (booster side) had been plugged with body caulk at the factory. Causing water to pool and enter through the hole(s) there.

Dig or drill out the caulk. Check the passenger side too.
--
1980 245 Canadian B21A with SU carb but electronic ignition and M46 trans in Brampton, Ont.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.