Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

A few E-code questions 200 1988

posted by  Brickhead Dick on  Fri Jul 15 22:07 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 29 08:56 CST 2013
[RELATED]

Hi All.

I'm about ready to install my euroheadlights. And I have a few questions.

I'm not the most electrical savvy, but I've done a few DC and AC projects. And I've managed to not burn anything down. Yet. ;)

I've gotten Daniel Stern's 9004 to H4 kit. Plenty of 12ga wire. Connectors, terminals, quick splices, etc. I've read plenty of older posts and I have Daniel Sterns upgraded h4 diagram.

My questions are: I want to wire in a redundancy using the old 9004 plugs. What would be the best way to go about that?

I'm also curious of where to run the hi/low signal output into the new relays for the upgraded circuit? Daniels diagram shows the signal going in/out through the firewall. If I can, I'd like to keep it all in the engine bay.

I'm gonna run the H4 lights off the battery. And besides these two questions it looks fairly straightforward. Thanks for any help you can lend.
--
'88 245,M47,Virgos,245K+






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New A few E-code questions [200][1988]
posted by  Brickhead Dick  on Fri Jul 15 22:07 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.