Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2018 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

heater control valve 700 1989

hello-
while doing the engine swap the heater control valve broke. i was holding the hose connected to it and the plastic just broke off inside the hose. anyway, i bought a new one and installed everything except the vacuum line that goes in it because frankly i am unsure which one it is. there is a tiny, little line that would seem to be the logical choice but it does not fit on the little nipple on the valve. i saw a picture online where there is a bigger hose connected to the end of a small line that goes onto the valve. is this correct? or is that little line incorrect? if so...what could it go to? thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New heater control valve [700][1989]
posted by  myribitsbroke subscriber  on Tue Jun 7 16:23 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.