Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2012 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Yet another wheel and offset question 120-130

posted by  tdskip on  Sun May 29 08:08 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Nov 13 21:12 CST 2011
[RELATED]

Hi guys - a month or so back I finally got around to test fitting the alloy rims I pulled of a ranger. They bolt pattern was correct at 5 on 4-1/2 (114.3 mm), and the width at 6 seemed fine but I ran into a clearance issue due to offset.

I've calculated the offset at 12, which isn't going to work.

From doing some searching on the forum it appears that a 6 offset would be OK, but I wanted to double check.

EDIT - two follow on questions. Would a spacer be an option to adjust the offset? Are longer well studs available?

Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Yet another wheel and offset question [120-130]
posted by  tdskip subscriber  on Sun May 29 08:08 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.