Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

pre pump pain in the rear 700

posted by  crazy_frog on  Mon Nov 15 16:49 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 9 14:05 CST 2011
[RELATED]

SO I have a couple posts going regarding my bosch fuel issue.

I had to bite the bullet and remove prepump again. I thought that I had it set right because it was marked. Then I was having trouble with my fuel gauge and it was running rough on low fuel.

These were new symptoms after my original work (replaced filter, pre and main pumps, and relay.

Today I took the assembly out and the pump was practically torn off the flimsy little bracket. What a pain. So, i guess i found the problem. Prepump needs to be set up right this time with pump connected to assembly.

Here is my question, I know that I need to use the sting trick but do I need to leave the sender expanded and then compress as I rotate or can I lock it in position with the string and then maneuver assembly into place?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New pre pump pain in the rear [700]
posted by  crazy_frog  on Mon Nov 15 16:49 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.