Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2021 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

blowing fuse #7 200 1990

I replaced the drivers side tail gate harness last night and the 3rd brake light was working along with the other two. Today I look and none are working. I found that fuse #7 is blowing when I press the brake pedal. I swapped out the bulb failure relay (big round red) and that didn't do anything. With this being a 1990 I can't figure out a way to access the brake light switch to try and jump it. What a joke that will be if its the problem.

I find it interesting that this happened the day after I replaced the tailgate harness. I unplugged the harness to the 3rd brake light and that didn't help. I looked at the tail lights and didn't find anything that would cause it to short out. Any ideas? If it is the brake light switch how do I go about getting at it. I already pulled the instrument cluster hoping to access it but couldn't see a way to it.

Trying to get this car some plates and I'm on my third and final temporary tag. I was getting so close to passing safety and now this.

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New blowing fuse #7 [200][1990]
posted by  transit wind subscriber  on Thu Oct 28 14:53 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.