Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

question about rewiring back hatch 200 1989

Well, I guess its about time. Our ‘89 wagons’ back hatch finally broke some wiring at the tail gate hinges which seems about par for course of 200 series wagons after 100k-200k miles or so. Did the passenger side hinge first. Sure enough, broken wires, replaced them with a good used set, in very good flexible condition. Old wiring was kinda brittle, the rear wiper had stopped working as did the hatch lock with using the door key or the inside locks, works great now. Need to do the other (drivers) side for the 2 license plate lights-(light bulbs are fine, all tested and all fuses good) BUT here’s my question -(finally)---there’s something else those wires control, I think, but just can not figure out what it is; far as I can see the only thing that drivers' side wiring controls is the license plate lights-am I missing something? By the way, all the wires broke right at the hinge joint. Thanks for any help you might be able to offer.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New question about rewiring back hatch [200][1989]
posted by  anthony2  on Tue Oct 26 17:18 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.