Dear Fellow Brickboarders,

Hope you're well. I need help to re-install the send unit. I have read the FAQs, thoroughly.

Problem: How to know when the unit is properly seated in the tank?

Help needed: at what position should be the four-wire connector at the top of the send unit, when the unit is properly seated? The four-wire connector, to which I refer, is that at the top of the send unit, where the wires go inside the fuel tank (not the grey plastic connector at the other end of wiring harness).

The FAQ instructions say to insert the send unit, with the barrel pointing towards the 3 o'clock position. It then must be rotated clockwise (to the right, as one faces the front of the car), so that the barrel points to 6 o'clock (back of the vehicle).

I can get the unit to seat, when the barrel points to the 3 o'clock position. This, though, seems wrong, to go by the FAQs.

It would be hugely helpful, if someone who has done this, can tell me at what clock position should be the four-wire connector, when the unit is properly seated.

I refer to the four-wire connector - easily seen (unlike the send unit's barrel, which is inside the tank) - because it cannot be confused with anything else at the top of the send unit.

Thanks for your help!!

Yours faithfully,

Spook