Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

steering rod installation [inner tie rod] 200

posted by  muskox37 on  Sat Oct 23 07:19 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 11:54 CST 2014
[RELATED]

Are there any tricks to installing the steering rod on the end of the rack. As far as I can see it appears to be a simple matter of screwing the rod into the rack, taking care not to damage the teeth of the rack. Not sure if I should use a thread lock fluid or if that will make future repairs extremely difficult.

I finally figured out how to install the bellows, using STP as a lubricant for the rubber. Worked like a charm. I now know that the line at the top of the bellows is to allow air to move back and forth between the two bellows.

Bob






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New steering rod installation &#091inner tie rod&#093 [200]
posted by  muskox37  on Sat Oct 23 07:19 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.