Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2009 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rad Temp Switch Retaining Nut - Aftermarket Application 900

posted by  brickie on  Tue Oct 19 02:17 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 28 05:18 CST 2010
[RELATED]

Hello,

I was wondering if someone was familiar with an aftermarket radiator that had a retaining nut (very large, close to 1 and ½ inches) holding in the fan temp switch? This radiator is an all metal type.

My switch does not seem to be working and I was going to replace it. I was wondering if the nut was just blow out protection and if there was any unique gaskets/rings under this nut before I take it off. The switch doesn’t work, but the thing doesn’t leak. I’d like to know if I need any additional parts (other than the new switch and rubber grommet) before I take it apart and possibly ruin something (gasket/ring) I cannot readily buy. I am hoping it is just a nut-ring that prevents the switch/grommet from blowing out.

TIA





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rad Temp Switch Retaining Nut - Aftermarket Application [900]
posted by  brickie  on Tue Oct 19 02:17 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.