Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2009

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

crank position sensor r&r completed.

posted by  Larue on  Sat Sep 25 03:42 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 30 17:46 CST 2014
[RELATED]

No problem
Just a little tricky to get a socket on.
Doused with PB blaster the night before, then about an hr before I started working. Once the bolt was off, part came out with no resistance whatsoever.
I used 1/4" inch drive with extension and 10mm socket. I found the 3/8 drive to be to thick.
Im assuming the PB blaster is why there was no resistance, but I cant swear to it.
Also, I found the cps wire had been burnt through. Probably the egr exhaust pipe.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 crank position sensor r&r completed.
posted by  Larue  on Sat Sep 25 03:42 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.