Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2001 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pinions Seal Replacement: Big Problem? 120-130

posted by  red92s on  Fri Jul 2 05:58 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 18 13:02 CST 2014
[RELATED]

I'm in the process of changing out my rear pinion seal. Got the pinion nut off in about 3 seconds with an impact, pulled the pinion off, and was feeling good about my progress.

Then I tried to remove the "dust cover and oil slinger" referred to in the Haynes manual, and encountered a major problem. I cannot seam to get this "dust cover" out. It is pretty well mangled at this point after repeated attempts to pry it out. I'm pretty much stuck until I can get it removed.

Have I made a serious misstep at some point along the way? Is this a part that should be so difficult to remove? It's pretty clear it's trashed at this point . . . are they still available?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pinions Seal Replacement: Big Problem? [120-130]
posted by  red92s subscriber  on Fri Jul 2 05:58 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.