Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

"New' Head or Junk Yard Engine 200

posted by  stogeyman on  Sun May 16 10:46 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 13 18:07 CST 2014
[RELATED]

I got a 1993 245, automatic for a song because I knew it had a blown head gasket. I removed the head, cleaned it up, put on a new gasket but didn't check the head for flatness. The thing started right up and idles nice but I can tell it's burning some coolant so the head needs work. Here's my situation and I'd like some opinions.

I don't mind removing the head and doing the job right this time (it's just not hard to do, plus I cleaned everything as I went so the engine compartment looks great). However, I'm worried that there might be other engine issues. So, I was thinking about getting an engine from a salvage yard, but then I'm actually in the same boat!

What would you do? Redo the head properly (the engine only has 160k miles on it)or go the salvage yard rout?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New &quot;New' Head or Junk Yard Engine [200]
posted by  stogeyman  on Sun May 16 10:46 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.