Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2006 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

fuel sender retaining nut 700 1992

posted by  triode52 on  Sun Jan 31 08:10 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 22 09:17 CST 2012
[RELATED]

Hello All,
I tried replacing the fuel sender on my 1992 745T and for the life of me I cannot get the plastic retaining nut that retains the fuel sender assembly back on. It is about 4.5" in diameter, plastic, and it is similar to a mason jar lid. I have tried for hours to get the nut started and it always wants to start a little sideways then it spins back off the threads as I continue turning. To my eyes the threads do not look damaged. However, I did notice in the Volvo instructions that the nuts can deform over time (it as been about 4 hours since I started the job) and this has me a little worried. Am I going to have to bum a ride to the dealership for a new nut or does anyone have any advice from doing this before? I have to admit that I am quite humbled by this since I have never spent 3 hours trying to start a nut before and I am staring to run out of patience and skin on my fingers. Any help or wisdom is greatly appreciated!

Thanks,

Mike






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New fuel sender retaining nut [700][1992]
posted by  triode52 subscriber  on Sun Jan 31 08:10 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.