Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Trouble tightening strut rod nut 200

posted by  dcooledge on  Fri Jan 22 18:03 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 9 07:48 CST 2014
[RELATED]

I replaced the struts in my 240, had a local garage replace one of the tie rod ends that I couldn't get off, and align the front end. I asked them to tighten everything down, and at first everything was tight and quiet. But then the driver's side strut rod started clunking. I tightened it down with my impact wrench, and it was okay around the block, but 1/2 mile down the road it started clunking again. Again, I tightened it down, and it was fine for awhile. But maybe I'm not tightening it enough.

Using an impact wrench, how do I know when the nut is tight enough so it won't come loose?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Trouble tightening strut rod nut [200]
posted by  dcooledge  on Fri Jan 22 18:03 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.