Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

vacuum at the ignition control module 200

posted by  4serge on  Sun Jan 3 16:01 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jan 21 12:43 CST 2013
[RELATED]

I was replacing vacuum lines on my 86 240GL, trying to fight high gas mileage. I found that the rubber line connecting plastic vacuum line to the ignition control module was plugged inside with a metal ball.

I assume it was done by PO or mechanic. What could be the possible reason to do this? Any ideas?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New vacuum at the ignition control module [200]
posted by  4serge  on Sun Jan 3 16:01 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.