Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

engine has bad "cold shakes' after being on the stand for 6 month 200 1993

It’s been almost three weeks since I finally put my new 93 red 245 on the road. I still haven’t cured the “cold shake”. At first, I try to deny that fact that the shake is just a little bit more than normal yet not a “violent” one. However, it is. It shakes every time I start the engine cold. It vibrates about an inch around. It stops when the temperature reaches half way to the middle. I tried everything I read from the previous posts and the FAQs. Nothing helped so far. Remember this started to occur after I did the oil pump job, replaced the fall-apart old mounts and a whole list of other things while I was there.

1. did the propane and carb cleaner spray trick, no leaks found.
2. replaced the IAC and AMM, no change.

Any suggestions? Thanks. Erwin






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New engine has bad &quot;cold shakes' after being on the stand for 6 month [200][1993]
posted by  eyyu  on Thu Dec 31 16:20 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.