Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2024 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Small hole in Header - suggestions needed 200

posted by  Mark Lundell on  Mon Nov 23 09:24 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 14 21:34 CST 2014
[RELATED]

I have a small hole in the header about 6 inches from the flange to the converter. The metal around the hole is solid. (It seems like the hole may have been from where the heat shield attached) I read in the FAQ that exhaust putty worked into wad of fire proof material held in place by a couple of good hose clamps may be a good temporary solution. What would be a good fireproof material to use and where would I get it?

Thanks for the help (again)

Mark






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Small hole in Header - suggestions needed [200]
posted by  Mark Lundell  on Mon Nov 23 09:24 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.